Volkswagen Jetta Junkies banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have some ESR Sr01 wheels that are 18x9.5 with a 35 offset all around for my 2008 jetta. The back ones fit flush but the front ones stick out too much.. is there any way I can still run that fitment in the front with out having to much poke ? I’m on coil overs the fronts are slammed (lowered two inches) and the rear is at normal ride height I also have a set of 15m, that I’m planning on putting for the front, since the back of the rim hits the strut. I did mess up on the fitment so I’m trying to make the best out of this situation I put myself in. Any suggestions will help me so much thank you 🙏🏼.
 
1 - 1 of 1 Posts
Top