Volkswagen Jetta Junkies banner

1 - 8 of 8 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
I've looked around and can't find a solution to my problem it's a 96 2.0 manual
Ac is charged and will blow cold with power to the compressor but fans don't kick on with push of ac switch but they do work when engine warms up I have checked all fuses and relays and nothing wrong there I have power to pressure switch
So major things are no fans with ac on but work normal and no power to compressor
Any ideas
 

·
Registered
Joined
·
9 Posts
Discussion Starter #2
I tried switching out the relay but that didn't do anything and yes it was with another #147 ac relay out of another jetta I'm wondering since the fan isn't kicking on with turning the ac on and the ac not working they are causing eachother to not work now is it the fcm or should I be looking somewhere else maybe the fan temp switch I jumped that to get to test the high and low speeds on the fan motors and that all checks out there is also supposed to be a 30 amp bus fuse above all the relays for the ac but there's nothing up there besides 1 10 amp fuse that's fine and there aren't any fuses missing cause there's no wires going into the back so maybe the fan control module I'm using parts off a jetta in the wrecking yard that had a bad tranny so I assume this stuff is fine
 

·
Registered
Joined
·
9 Posts
Discussion Starter #3
Does anyone have a wiring diagram of the fuse and relays that has everything I'm in deep into some burnt wiring in the dash and need to check for continuity there's a red and black wire that also broke that has a green connector that I can't find the other end of so I'm in deep now
Also when I start the car the park lights automatically come on even when the headlights are off

Power going into relay 13 labeled 147 nothing coming out tried 2 relays and nothing with both
 

·
Registered
Joined
·
9 Posts
Discussion Starter #7
Yep did that I'm gonna go with the ac pressure switch and if that doesn't fix it then I'll be done messing with it and deal with no ac or just wire in a switch that will send power and ground to the compressor and by pass everything else
 
1 - 8 of 8 Posts
Top